AT-9000 Switch Command Line User’s Guide
931
SWITCHPORT PORT-SECURITY
Syntax
switchport port-security
Parameters
None
Mode
Port Interface mode
Description
Use this command to activate MAC address-based security on ports.
Confirmation Command
“SHOW PORT-SECURITY INTERFACE” on page 926
Example
This example activates MAC address-based security on port 3 and ports
16 to 18:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3,port1.0.16-port1.0.18
awplus(config-if)# switchport port-security
To Next Page
Loading...
