Allied Telesis AT-9000 Series - Displaying EAP Packet Statistics; Figure 164: SHOW DOT1 X STATISTICS INTERFACE Command

AT-9000 Switch Command Line User’s Guide
961
Displaying EAP Packet Statistics
To display EAP packet statistics of authenticator ports, use the SHOW
DOT1X STATISTICS INTERFACE command. Here is an example of the
information. This example displays the authenticator settings for port 1.0.2:
awplus> enable
awplus# show dot1x statistics interface port1.0.2
Figure 164. SHOW DOT1X STATISTICS INTERFACE Command
Authentication Statistics for interface port1.0.2
EAPOL Frames Rx: 0 - EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 0 - EAP Response Frames Rx: 0
EAP Req/Id Frames Tx: 0 - EAP Request Frames Tx: 0
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 0 - EAPOL Last Frame Src: 0000.0000.0000