Chapter 63: 802.1x Port-based Network Access Control Commands
990
NO AUTH DYNAMIC-VLAN-CREATION
Syntax
no auth dynamic-vlan-creation
Parameters
None
Mode
Port Interface mode
Description
Use this command to disable dynamic VLAN assignments of
authentication ports. For background information, refer to “Supplicant and
VLAN Associations” on page 947.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 995
“SHOW DOT1X INTERFACE” on page 1000
Example
This example disables dynamic VLAN assignment of authenticator port
1.0.15:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15
awplus(config-if)# no auth dynamic-vlan-creation
To Next Page
Loading...
