Chapter 63: 802.1x Port-based Network Access Control Commands
994
NO DOT1X PORT-CONTROL
Syntax
no dot1x port-control
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove ports from the authenticator role so that they
forward traffic without authentication.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 995 or “SHOW DOT1X
INTERFACE” on page 1000
Example
This example removes port 1.0.14 from the authenticator role:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.14
awplus(config-if)# no dot1x port-control
To Next Page
Loading...
