AT-9000 Switch Command Line User’s Guide
997
SHOW AUTH-MAC STATISTICS INTERFACE
Syntax
show auth-mac statistics interface
port
Parameters
port
Specifies a port. You can enter more than one port.
Mode
Privileged Exec mode
Description
Use this command to display EAP packet statistics of authenticator ports.
This command is equivalent to “SHOW DOT1X STATISTICS INTERFACE
Command” on page 1001. An example is shown in Figure 167.
Figure 167. SHOW AUTH-MAC STATISTICS INTERFACE Command
Example
This example displays the EAP packet statistics of authenticator port
1.0.7:
awplus# show auth-mac statistics interface port1.0.7
Authentication Statistics for interface port1.0.2
EAPOL Frames Rx: 0 - EAPOL Frames Tx: 0
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 0 - EAP Response Frames Rx: 0
EAP Req/Id Frames Tx: 0 - EAP Request Frames Tx: 0
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 0 - EAPOL Last Frame Src: 0000.0000.0000
To Next Page
Loading...
Need help?
General
