Allied Telesis AT-9000 Series - Show Auth-Mac Supplicant Interface; Figure 168: SHOW AUTH-MAC SUPPLICANT INTERFACE Command

Chapter 63: 802.1x Port-based Network Access Control Commands
998
SHOW AUTH-MAC SUPPLICANT INTERFACE
Syntax
show auth-mac supplicant interface port
Parameters
port
Specifies a port. You can enter more than one port.
Mode
Privileged Exec mode
Description
Use this command to display the supplicant state of the authentication
mode set for the interface on authenticator ports. This command is
equivalent to “SHOW DOT1X SUPPLICANT INTERFACE Command” on
page 1002. An example is shown in Figure 168.
Figure 168. SHOW AUTH-MAC SUPPLICANT INTERFACE Command
Example
This example displays the supplicant state of the authentication mode on
ports 1.0.21 and 1.0.23:
awplus# show auth-mac supplicant interface port1.0.21-
port1.0.23
Interface port1.0.3
authenticationMethod: dot1x
totalSupplicantNum: 0
authorizedSupplicantNum: 0
macBasedAuthenticationSupplicantNum: 0
dot1xAuthenticationSupplicantNum: 0
webBasedAuthenticationSupplicantNum: 0
otherAuthenticationSupplicantNum: 0
No supplicants