28 x900 Series Switch and SwitchBlade
®
x908
C613-03092-00 REV J
Managing the File System chapter in the AlliedWare
®
Operating System Software
Reference.
On switches running the AlliedWare Plus operating system, use the
commands:
awplus#show file systems
awplus#dir card:/
Testing the slot On switches running the AlliedWare operating system, you can test the SD
card slot on front of the switch to verify that the hardware does the following:
■ detects the presence of a card
■ detects whether a card has been exchanged
■ detects write-protection on a card
■ transfers data to and from a card
The test does not write data to the card or harm existing data. To test the slot,
use the command:
enable test device=card type=slot
Output is sent to the management asynchronous port. For more information
about testing the card slot, see the Test Facility chapter in the AlliedWare
®
Operating System Software Reference.
To Next Page
Loading...
