Allied Telesis AT-FS750 - SSH Server Configuration

AT-FS750/24-41 Web User Interface Manual
5-7
Figure 18 – System > SNMP > Trap Manager
Parameter
Description
Host IP Address
The IP address of a host that can access to the device by SNMP.
SNMP version
Specify the SNMP version to be used, which can be v1, v2c, or v3.
Community
Name/User Name
The name of SNMP community/user that the host belongs to.
Click ADD to submit the changes and the Reset button will clear the information inputed. Select and click
Delete to remove an existed entry.
SNMP Engine ID Configuration
This page is to configure the SNMP engine identifier of the device.
Figure 19 – System > SNMP > Engine ID
Parameter
Description
Engine ID
A string of between 5 and 32 octets expressed in hexadecimal. The default is
8000081c044653.
Click ADD to submit the changes and the Reset button will clear the information inputed.
SSH Configuration
This page is to configure the SSH server function on the device.
Figure 20 – System > SSH
Parameter
Description
SSH Status
Select Enable or Disable to turn on or off the SSH server function. Default is
enabled.