Allied Telesis AT-FS750 - SNTP and Time Settings

AT-FS750/24-41 Web User Interface Manual
5-9
Figure 22 – System > System Log
Parameter
Description
Syslog Status
The status of syslog server function. Default is enabled.
Time Stamp
Specifies if time stamp is attached with syslog messages. Default is enabled.
Messages Buffered
Size (1-200)
The size of internal logging buffer. Default is 50.
Syslog Server IP
IP address of the external syslog server
Mail Server IP
Specify the IP address of mail server to be used for sending the email alerts
messages.
Receiver Email
Address
The email address of receiver that receives the alert messages.
Serder Email Address
The email address of sender that sends out the alert messages.
Facility
Specifies the facility that is indicated in the message. Possible values: local0,
local1, local2, local3, local4, local5, local6, and local7. Default is Local0.
Logging Level
Specifies the severity level of messages. Possible values are:
Alert level: action must be taken immediately.
Critical level: Critical conditions.
Debug level: Debug messages.
Emergency level: System is unusable.
Error level: Error conditions.
Informational level: Informational messages.
Notification level: Normal but significant condition.
Warning level: Warning conditions.
Default is info.
Click Apply to submit the changes.
SNTP
SNTP and Current Time Settings
This page is to configure SNTP and time settings.
Figure 23 – System > SNTP > Time Settings
Parameter
Description
Current Time
Current system time.
SNTP Status
To enable/disable the Simple Network Time Protocol (SNTP) function. Defualt