Allied Telesis AT-FS750 - MSTP VLAN Mapping

AT-FS750/24-41 Web User Interface Manual
6-10
Figure 40 – Layer2 Management > MSTP > Port Configuration
Parameter
Description
Select
Select a port to apply the configuration changes.
Port
Port ID.
Path Cost
Specify the path cost of the port. Possible value is 0-200000000. Default
200000000
Priority
Specify the spannping tree port priority. Possible value is 0-240. Default is
128.
Point to Point Status
Specify the link type of this port. ForceTure means link type is point to point;
ForceFalse means it is shared; Auto means the decision will made
automatically. Default is auto.
Edge Port
Specify if this port is edge port or not. Select True to enable the portfast
function, False to disable it. Default is false.
MSTP Status
To enable or disable the MSTP on this port. Select Enable to enable MSTP on
this port, Disable to disable it. Default is enabled.
Protocol Migration
To control if the port will migrate among MSTP, RSTP and STP automatically if
another switch runs different protocol. Select True to enable the protocol
migration function, Fales to disable it. Defalue is False.
Hello Time
Specify the hello time of this port. Possible value is 1-2. Default is 2.
AutoEdge Status
To enable or disable the autoedge detection of this port. Select True to enable
the autoedge function, False to disable it. Default true.
Restricted Role
To enable or disable the root guard function to prevent the port becoming a
root port. Select Ture to enable the root guard function, False to disable it.
Default is false.
Restricted TCN
To enable the topology change guard function to prevent the topology change
caused by this port. Select Ture to enable the topology change guard
function, False to disable it.Default is false.
Click Apply to submit the changes.
MSTP VLAN Mapping
This page is to configure the MST Instance and VLAN mapping.