Allied Telesis AT-FS750 - LA Port Settings; LA Port Statemachine Information

AT-FS750/24-41 Web User Interface Manual
6-17
LA Port Settings
This page is to configure port related link aggregation settings.
Figure 51 – Layer2 Management > LA > Port Settings
Parameter
Description
Select
Select a port to submit the changes.
Port
Port ID.
Port Priority
Specify the link aggregation port priority of this port. Possible value are
0-65535. Default is 128.
Port Identifier
Port ID.
Mode
Specify the mode of this port channel. Possible options are Lacp, Manual and
Disable.
Activity
Specify the LACP mode of the port. Select Active to activate the LACP
negotiation; select Passive that LACP negotiation starts only when LACP
packet is received. Default is Active.
Timeout
To choose the LACP timeout period when no packet receive from peer. Long
specifies a long time out value. LACP PDU will be sent every 30 seconds and
LACP timeout value is 90 seconds. Short specifies a short time out value.
LACP PDU will be sent every 1 seconds and LACP timeout value is 3 seconds
Wait Time (secs)
Specify the period that ports get aggregated after receiving LACP PDU.
Possible value is 0-10 seconds. Default is 2.
Bundle State
Specify the current LA state of this port. And the states descriptions are:
Up in Bundle - This port is an active member of a port channel.
Up Individual - This port is not a member of any port channel but its operation
state is Up.
Standby - This port is a standby member of a port channel.
Down - This port operation state is down.
Click Apply to submit the changes.
Click 1-12, 13-24, 25-28 to configure LA port settings for corresponding ports.
LA Port StateMachine Information
This page is to display the LA state of each port.