Allied Telesis AT-FS750 - IP Standard ACL Configuration

AT-FS750/24-41 Web User Interface Manual
7-3
Figure 68 – ACL > IP Standard ACL
Parameter
Description
ACL Number
Specify the ACL ID of this rule. The possible ID of IP Standard ACL is 1-1000.
Action
Specify the action for packet matched. Select Permit to process the packets,
Deny to discard them.
Source IP Address
Matching packet with a specific source IP address.
Subnet Mask
Matching packet with a range of source IP address. For example 172.17.5.1
with mask 255.255.255.0 means 172.15.5.0~255.
Destination IP Address
Matching packet with a specific destination IP address.
Subnet Mask
Matching packet with a range of destination IP address. For example
172.17.5.1 with mask 255.255.255.0 means 172.15.5.0~255.
Port List (Incoming)
Specify the ports to apply this ACL rule.
Click Add to create a new ACL rule, Reset to clear the value just inputed.
Parameter
Description
Select
Select an ACL rule to apply the configuration changes.
ACL Number
Specify the ACL ID of this rule.
Action
Specify the action for packet matched. Select Permit to process the packets,
Deny to discard them.
Source IP Address
Matching packet with a specific source IP address.
Subnet Mask
Matching packet with a range of source IP address. For example 172.17.5.1
with mask 255.255.255.0 means 172.15.5.0~255.
Destination IP Address
Matching packet with a specific destination IP address.
Subnet Mask
Matching packet with a range of destination IP address. For example
172.17.5.1 with mask 255.255.255.0 means 172.15.5.0~255.
Port List (Incoming)
Specify the ports to apply this ACL rule.
Click Apply to submit the changes to the ACL rule, Delete to delete it.
IP Extended ACL Configuration
This page is to create/configure a rule to IP Extended Access Control List.