Allied Telesis AT-GS900M Series - Show Log Output

AT-GS900M Series CLI Reference
Section II: Switch Management 109
SHOW LOG OUTPUT
Syntax
show log output
Parameters
None
Description
Use this command to display the log settings:
An example of the command output is shown in Figure 15.
Figure 15. SHOW LOG OUTPUT Command
Example
The following command displays the log settings:
Manager> show log output
Output Type Status Server Port Msg LogLv Facility
----------------------------------------------------------------------------
PERMANENT NVS Enabled - - 3000 >0 -
SYSLOG SYSLOG Disabled Not set 514 - >0 DEFAULT
----------------------------------------------------------------------------