Chapter 7: SNMP Commands
132 Section II: Switch Management
SET SNMP LISTENPORT
Syntax
set snmp listenport=
port_number
Parameters
port_number
Specifies the number of UDP port for SNMP. The port number is
from 1 to 65535. By default, the UDP port for SNMP is 161.
Description
Use this command to change the UDP port for SNMP.
Confirmation Command
“SHOW SNMP” on page 137
Example
The following command changes the UDP port for SNMP to 200:
Manager > set snmp listenport=200
To Next Page
Loading...
