Allied Telesis AT-GS900M Series - Chapter 9: Telnet Commands

AT-GS900M Series CLI Reference
Section II: Switch Management 161
Chapter 9
Telnet Commands
The Telnet commands are summarized in Table 20.
Table 20. Telnet Commands
Command Description
“DISABLE TELNET SERVER” on
page 162
Disables the Telnet server on the switch.
“ENABLE TELNET SERVER” on
page 163
Enables the Telnet server on the switch.
“SET ASYN” on page 164 Enables or disables logging in from the
Console port.
“SET CONSOLE” on page 165 Specifies the settings of sessions from the
Console port.
“SET TELNET” on page 167 Specifies the settings of sessions through
Telnet.
“SHOW ASYN” on page 168 Displays whether logging in from the
Console port is enabled or disabled.
“SHOW CONSOLE” on page 169 Displays the settings of the Console port,
Telnet, and sessions from the Console port
and Telnet.
“SHOW TELNET” on page 171 Displays the settings of Telnet.
“TELNET” on page 172 Starts a Telnet session from the local
management session from the Console
port.