Chapter 12: IP Management Commands
206 Section III: Layer 2 Switching
SHOW IP
Syntax
show ip
Parameters
None
Description
Use this command to display the settings of IP address on the switch. An
example of the command output is shown in Figure 33.
Figure 33. SHOW IP Command
The fields are described in Table 28.
Table 28. SHOW IP Command
Field Description
Type Displays the assignment type of the IP address.
The options are:
Static
Dynamic: assigned by DHCP
Interface Displays the VLAN interface that the IPv4 address
is assigned to.
IP address Displays the IPv4 address.
Subnet mask Displays the subnet mask.
Gateway address Displays the IPv4 address of the gateway.
MTU Displays the maximum size of transmitting packets.
IP Address Information
--------------------------------------------------------
Type ....................... Static
Interface .................. default
IP address ................. 192.168.1.105
Subnet mask ................ 255.255.255.0
Gateway address ............ 0.0.0.0
MTU ........................ 1500
DHCP Client ................ Disabled
Directed broadcast ......... No
--------------------------------------------------------
To Next Page
Loading...
Need help?
General
