Chapter 14: Switching Commands
222 Section III: Layer 2 Switching
ACTIVATE SWITCH PORT AUTONEGOTIATE
Syntax
activate switch port=
port_list
|all autonegotiate
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to enable Auto-negotiation to the specified ports.
Confirmation Command
“SHOW SWITCH PORT” on page 272
Example
The following command enables Auto-negotiation to all ports:
Manager > activate switch port=all autonegotiate
To Next Page
Loading...
