Chapter 14: Switching Commands
244 Section III: Layer 2 Switching
ENABLE SWITCH PORT AUTOMDI
Syntax
enable switch port=
port_list
|all automdi
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports except SFP and combo ports.
Description
Use this command to enable switch ports to automatically detect MDI or
MDI-X. By default, the MDI auto detection is enabled.
Here are guidelines for using this command:
The SFP and combo ports cannot be disabled the MDI auto-
detection by this command.
You cannot disable the MDI auto-detection on trunk ports.
You can add the ports that the MDI auto-detection is disabled to a
trunk group.
The port that is set the 100M speed cannot be disabled the MDI
auto detection by this command.
Confirmation Command
“SHOW SWITCH” on page 267
Example
The following command enables the MDI auto-detection on port 3:
Manager > enable switch port=3 automdi
To Next Page
Loading...
