Chapter 14: Switching Commands
252 Section III: Layer 2 Switching
SET SWITCH LIMITATION
Syntax
set switch limitation[=none|0|
reveiving_rate
]
Parameters
none, 0
Disables the packet storm protection. The default value is 0.
reveiving_rate
Specifies the maximum receiving rate. The range is 1 to 1024000
Kbps.
Description
Use this command to specify the maximum receiving rate for the packet
storm protection. When the keyword none or 0 is specified, the packet
storm protection is disabled. By default, the packet storm protection is
disabled.
Confirmation Command
“SHOW SWITCH STORMDETECTION” on page 276
Example
The following command sets the maximum receiving rate to 10240 Kbps:
Manager > set switch limitation=10240
To Next Page
Loading...
