Allied Telesis AT-GS900M Series - Show Switch

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 267
SHOW SWITCH
Syntax
show switch
Parameters
None
Description
Use this command to display information about the switch settings. An
example of the command output is shown in Figure 35.
Figure 35. SHOW SWITCH Command
Example
The following example displays information about the switch:
Manager > show switch
Switch Configuration
-----------------------------------------------
Switch Address ............ 00-09-16-00-00-02
Ageingtimer ............... On
Number of Fixed Ports ..... 16
Mirroring ................. Disabled
Mirror port ............... None
Ports mirroring on Rx ..... None
Ports mirroring on Tx ..... None
Ports mirroring on Both ... None
BPDU Forwarding ........... Disabled
EAP Forwarding ............ Disabled
Powersaving ............... Disabled
Ageingtime ................ 300
UpTime .................... 00:34:57
-----------------------------------------------