Chapter 14: Switching Commands
278 Section III: Layer 2 Switching
SHOW SWITCH TRUNK
Syntax
show switch trunk=
trunk
Parameters
trunk
Specifies a trunk group to display its information.
Description
Use this command to display information about trunk groups. An example
of the command output is shown in Figure 42.
Figure 42. SHOW SWITCH TRUNK Command
Example
The following example displays information about trunk groups:
Manager > show switch trunk
Switch Trunk Group
--------------------------------------------------------
Trunk group name ... uplink
Speed .............. 1000 Mbps
Ports .............. 1-8
--------------------------------------------------------
To Next Page
Loading...
