Chapter 15: Ethernet Protected Switched Ring (EPSR) Commands
280 Section III: Layer 2 Switching
ADD EPSR DATAVLAN
Syntax
add epsr=
epsr_name
datavlan=[
vlan_name
|
vlan_id
]
Parameters
epsr_name
Specifies an EPSR domain.
datavlan
Specifies a data VLAN with a VLAN name or VLAN ID.
Description
Use this command to add a data VLAN to the Ethernet Protected Switched
Ring (EPSR) domain. Data VLANs carry data traffic that EPSR protects
from looping.
Here are guidelines for data VLAN:
One EPSR domain can have up to 255 data VLANs.
A data VLAN to an EPSR domain can be added as a data VLAN to
another EPSR domain if the EPSR domains are not connected to
the same ports.
A control VLAN that is assigned to an EPSR domain cannot be add
as a data VLAN.
A VLAN associated to an MST instance of Multiple Spanning Tree
Protocol (MSTP) cannot be added as a data VLAN.
Confirmation Command
“SHOW EPSR” on page 288
Example
The following command adds VLAN 50 to the EPSR domain “epsr1:”
Manager > add epsr=epsr1 datavlan=50
To Next Page
Loading...
