Allied Telesis AT-GS900M Series - Show Epsr

Chapter 15: Ethernet Protected Switched Ring (EPSR) Commands
288 Section III: Layer 2 Switching
SHOW EPSR
Syntax
show epsr[= epsr_name |all]
Parameters
epsr_name
Specifies an EPSR domain.
all
Specifies all ESPR domains.
Description
Use this command to display information about the EPSR domain. An
example of the command output is shown in Figure 43.
Figure 43. SHOW EPSR Command
Example
The following example displays information about the EPSR domains on
the switch:
Manager > show epsr
EPSR Information
--------------------------------------------------------
Name ........................ blue
Mode .......................... AWARE
Status ........................ Enabled
State ......................... Links-Up
Delete Multicast Entry ........ Disabled
Control Vlan .................. control (2)
Data VLAN(s) .................. data (100)
First Port .................... 1
First Port Status ............. Up
First Port Direction .......... Downstream
Second Port ................... 2
Second Port Status ............ Up
Second Port Direction ......... Upstream
Master Node ................... 00-00-cd-24-03-4e
--------------------------------------------------------