Chapter 17: DHCP Snooping Commands
316 Section III: Layer 2 Switching
ENABLE DHCPSNOOPING ARPSECURITY
Syntax
enable dhcpsnooping arpsecurity
Parameters
None
Description
Use this command to set ARP security enabled. ARP security is enabled
when DHCP Snooping is enabled. When ARP security is enabled, the
switch forwards ARP packets from DHCP clients and discards the rest. By
default, ARP security is disabled.
Confirmation Command
“SHOW DHCPSNOOPING” on page 328
Example
The following command sets ARP security enabled:
Manager > enable dhcpsnooping arpsecurity
To Next Page
Loading...
