Allied Telesis AT-GS900M Series User Manual

Chapter 17: DHCP Snooping Commands
330 Section III: Layer 2 Switching
SHOW DHCPSNOOPING DATABASE
Syntax
show dhcpsnooping database
Parameters
None
Description
Use this command to display the DHCP Snooping table. An example of
the command output is shown in Figure 49.
Figure 49. SHOW DHCPSNOOPING DATABASE Command
Example
The following example displays the DHCP Snooping table:
Manager > show dhcpsnooping database
DHCP Snooping Binding Database
--------------------------------------------------------------------------
Full Leases/Max Leases ... 2/24
Check Interval ........... 60 seconds
Check Options ............ None
Current valid entries
MAC Address IP Address Expires(s) VLAN Port ID Source
----------------------------------------------------------------------------
00-00-00-00-00-01 192.168.10.5 Static 1 5 4 User
00-0a-79-34-06-12 192.168.10.200 2231 1 11 1 Dynamic
--------------------------------------------------------------------------
Entries with client lease but no listeners
MAC Address IP Address Expires(s) VLAN Port ID Source
-----------------------------------------------------------------------------
None...
-----------------------------------------------------------------------------
Entries with no client lease and no listeners
MAC Address IP Address Expires(s) VLAN Port ID Source
-----------------------------------------------------------------------------
None...
-----------------------------------------------------------------------------

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English