Allied Telesis AT-GS900M Series - Enable Poe Port

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 335
ENABLE POE PORT
Syntax
enable poe port[= port_list |all]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to enable Power of Ethernet (PoE) on the specified
ports. By default, PoE is enabled on all ports.
Note
The PoE commands are available only for the GS908M V2-4PS
switch.
Confirmation Command
“SHOW POE” on page 342
Example
The following command enables PoE on port 1 to port 2:
Manager > enable poe port=1-2