AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 337
SET POE GUARDBAND
Syntax
set poe guardband=
guard_band
Parameters
guard_band
Specifies the guard band in watts. The range is 2 to 70 watts. The
default setting is 10 watts.
Description
Use this command to specify guard power in watts. The switch does not
supply power to a PD that is newly connected to the port when the switch
is supplying power to the other PDs exceeding the power threshold. The
power threshold is the maximum power 75 watts minus the specified guard
band. For example, when the guard band is 25 watts, the switch does not
supply power to a new PD if the switch is supplying power to other PDs
exceeding 50 (75 minus 25) watts.
The PoE commands are available only for the GS908M V2-4PS
switch.
Confirmation Command
“SHOW POE” on page 342
Example
The following command specifies 25 watts to the guard band:
Manager > set poe guardband=25
To Next Page
Loading...
