Allied Telesis AT-GS900M Series - Show Stp

AT-FS900M Series CLI ReferenceAT-GS900M Series CLI Reference
Section III: Layer 2 Switching 371
SHOW STP
Syntax
show stp
Parameters
None.
Description
You use this command to display the RSTP parameter settings. An
example of the command is shown in Figure 56.
Figure 56. SHOW STP Command
The fields are described in Table 42.
STP Information
------------------------------------------------
RSTP Type .................... Normal
Number of Ports .............. 16
Number Enabled ............ 4
Number Disabled ........... 12
Enable Port List ............. 1-4
Bridge Identifier ............ 32768 : 00:21:46:A7:B4:11
Bridge Priority .............. 32768
Root Bridge .................. 32768 : 00:21:46:A7:B4:11
Root Port .................... (n/a)
Root Path Cost ............... 0
Max Age ...................... 20
Hello Time ................... 2
Forward Delay ................ 15/15
Switch Max Age ............... 20
Switch Hello Time ............ 2
Switch Forward Delay ......... 15/15
Hold Time .................... 1
Table 42. SHOW STP Command
Column Description
RSTP Type Indicates whether the switch is
operating in the normal RSTP
mode or STP compatible mode.
Number of Ports Indicates the number of ports on
the switch.
Number Enabled Displays the number of ports on
which RSTP is enabled.