Allied Telesis AT-GS900M Series - Show Mstp

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 399
SHOW MSTP
Syntax
show mstp [portconfig= port_list |all]
[portstate=
port_list |all] [mstistate= instance ] [cist]
[mstivlanassoc]
Parameters
portconfig
Displays the settings of the specified port.
portstate
Displays the state of the specified port.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
mstistate
Displays the state of the specified MST instance.
cist
Displays the state of CIST.
mstivlanassoc
Displays the mapping table of MST instances and VLANs.
Description
Use this command to display the settings and state of MSTP and CIST.
See Figure 59 on page 400 for an example.