AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 411
ENABLE ACCESS FILTER
Syntax
enable access filter=snmp|ftp|telnet|http|icmp|global|all
Parameters
filter
Specifies an access filter group. See “ADD ACCESS FILTER” on
page 406.
global
Specifies all the access filter groups.
all
Specifies the access filter entries: snmp, ftp, telnet, http, and icmp.
Description
Use this command to enable the access filter feature on the specified
access filter group or all the access filter entries.
Confirmation Command
“SHOW ACCESS FILTER” on page 415
Example
The following command enables the access filter features for SNMP
service:
Manager > enable access filter=snmp
To Next Page
Loading...
