Chapter 26: Policy-Based QoS Commands
458 Section IV: Security and Traffic Control
ADD QOS POLICY
Syntax
add qos policy=
policy_number
trafficclasslist=
tc_list
|none
Parameters
policy_number
Specifies a QoS policy number. The range is 0 to 255.
tc_list
Specifies a list of classifiers. To specify multiple traffic classes, use
a comma (,) to separate them. To specify a range of traffic classes,
use a hyphen (-).
Description
Use this command to associate traffic classes to a QoS policy.
Confirmation Command
“SHOW QOS POLICY” on page 494
Example
The following command adds traffic classes 1, 2, and 3 to QoS policy 1:
Manager > add qos policy=1 traffcclasslist=1-3
To Next Page
Loading...
