Allied Telesis AT-GS900M Series - Add Qos Trafficclass

AT-GS900M Series Command Reference
Section IV: Security and Traffic Control 459
ADD QOS TRAFFICCLASS
Syntax
add qos trafficclass= traffic_class_number
flowgrouplist=
flow_list |none
Parameters
traffic_class_number
Specifies a traffic class number. The range is 0 to 511.
flow_list
Specifies a list of flow groups. To specify multiple flow groups, use
a comma (,) to separate them. To specify a range of flow groups,
use a hyphen (-).
Description
Use this command to associate flow groups to a traffic class.
Confirmation Command
“SHOW QOS TRAFFICCLASS” on page 496
Example
The following command associates flow groups 1 and 2 to traffic class 1:
Manager > add qos trafficclass=1 flowgrouplist=1-3