Allied Telesis AT-GS900M Series - Show Qos Policy

Chapter 26: Policy-Based QoS Commands
494 Section IV: Security and Traffic Control
SHOW QOS POLICY
Syntax
show qos policy[= policy_list |all]
Parameters
port_list
Specifies a list of QoS policies. To specify multiple policies, use a
comma (,) to separate them. To specify a range of policies, use a
hyphen (-).
Description
Use this command to display the settings of QoS policies. An example of
the command output is shown in Figure 73.
Figure 73. SHOW QOS POLICY Command
Example
The following example displays the settings of QoS policy 1:
Manager > show qos policy=1
---------------------------------------------
Policy ID ............ 1
Description ..........
Remark DSCP .......... None
In DSCP Overwrite ....
Traffic Class List ...
Redirect Port ........
Ingress Port List ....
Egress Port List .....
Is Active ............ No