Chapter 3: Basic CLI Management Commands
50 Section I: Getting Started
SET INSTALL
Syntax
set install=preferred release=
software_file
Parameter
software_file
Specifies the name of the management software image file. The
file name must be in the following format:
gs900mv2_vnnnn.rel
The preferred keyword is the only option to set install command.
Description
Use this command to select a software image file as the boot configuration
file that runs on the switch next time the switch reboots. The switch can
save up to two management software image files in the file system.
Confirmation Command
“SET INSTALL” on page 50
Example
The following command selects the gs900mv2_v232.rel image file as the
boot configuration file to run on the switch after the switch reboots:
manager > set install=preferred release=gs900mv2_v232.rel
To Next Page
Loading...
Need help?
General
