Chapter 27: Port-Based Authentication Commands
538 Section IV: Security and Traffic Control
SHOW WEBAUTHSERVER
Syntax
show webauthserver
Parameters
None
Description
Use this command to display information about Web-Based
Authentication. An example of the command output is shown in Figure 79.
Figure 79. SHOW WEBAUTHSERVER Command
Example
The following example displays information about Web-Based
Authentication:
Manager > show webauthserver
Manager > show webauthserver
Web Authentication Server Module Configuration:
---------------------------------------------------------
Status : Enabled
TCP port : 8080
RedirectURL :
Message1 : Allied-Telesis
Message2 : User Login
Message3 :
Message4 :
Message5 : Copyright (C) Allied Telesis K.K.
To Next Page
Loading...
