Allied Telesis AT-GS900M Series - Page 59

AT-GS900M Series CLI Reference
Section I: Getting Started 59
The fields are described in Table 5.
Table 5. SHOW SYSTEM Command
Field Description
Bay N/A
Board Name Displays the name of the device.
DRAM Displays the size of the DRAM on the switch.
FLASH Displays the size of the FLASH memory on the switch.
MAC Displays the MAC address of the switch.
SysDescription Displays the system description, the value of the
sysDesr MIB-II object.
SysContact Displays the contact, the value of the sysContact MIB-
II object.
SysLocation Displays the location, the value of the sysLocation
MIB-II object.
SysName Displays the contact, the value of the sysName MIB-II
object.
SysUpTime Displays the time since the switch last restarted.
Release Version Displays the version of the management software
Release built Displays the time stamp of the management software.
Flash PROM Displays the result of the checksum calculation for the
program data in Flash memory. The options are Good
and Failed.
RAM Displays the result of the RAM test at rebooting. The
options are Good and Failed.
SW chip Displays the result of the switch chip test at rebooting.
The options are Good and Failed.
UART Displays the result of the UART test at rebooting. The
options are Good and Failed.
PoE Displays the result of the PoE test at rebooting. The
options are Good and Failed. It is available only for
GS908M V2-4PS models.
FAN1 Displays the status of the fan. The options are Normal,
Warning, and Failed. Failed means that the switch
failed to read the data. It is not available for GS908M
V2 models.