Allied Telesis AT-GS900M Series - Chapter 6: Log Commands

AT-GS900M Series CLI Reference
Section II: Switch Management 95
Chapter 6
Log Commands
The log commands are summarized in Table 9.
Table 9. Log Commands
Command Description
“DISABLE LOG” on page 96 Disables logging.
“DISABLE LOG OUTPUT” on
page 97
Disables the permanent log, the syslog, or
both.
“ENABLE LOG” on page 98 Enables logging.
“ENABLE LOG OUTPUT” on
page 99
Enables the permanent log, the syslog, or
both.
“FLUSH LOG OUTPUT” on
page 100
Deletes the log messages of the specified
log.
“PURGE LOG” on page 101 Deletes the log settings and counters.
“SET LOG OUTPUT” on page 102 Configure the permanent log and syslog.
“SHOW CRASHLOG” on
page 105
Displays log messages stored in the Non-
Volatile (NV) memory.
“SHOW LOG” on page 106 Displays log messages.
“SHOW LOG COUNTER” on
page 108
Displays log counters.
“SHOW LOG OUTPUT” on
page 109
Displays the log settings.
“SHOW LOG STATUS” on
page 110
Displays the log status.