Allied Telesis AT-GS908M - Show Snmp

AT-GS900M Series CLI Reference
Section II: Switch Management 137
SHOW SNMP
Syntax
show snmp
Parameters
None
Description
Use this command to display the SNMP configuration and SNMP
counters. An example of the command output is shown in Figure 19.
Figure 19. SHOW SNMP Command
SNMP Module Configuration:
--------------------------------------
Status : Disabled
SNMP Manager Listen Port : 161
SNMPTRAP Listen Port : 162
--------------------------------------
SNMP counters:
-------------------------------------------------------------------
inPkts : 0 outPkts : 0
inBadVersions : 0 outTooBigs : 0
inBadCommunityNames : 0 outNoSuchNames : 0
inBadCommunityUses : 0 outBadValues : 0
inASNParseErrs : 0 outGenErrs : 0
inTooBigs : 0 outGetRequests : 0
inNoSuchNames : 0 outGetNexts : 0
inBadValues : 0 outSetRequests : 0
inReadOnlys : 0 outGetResponses : 0
inGenErrs : 0 outTraps : 0
inTotalReqVars : 0
inTotalSetVars : 0
inGetRequests : 0
inGetNexts : 0
inSetRequests : 0
inGetResponses : 0
inTraps : 0