Chapter 7: SNMP Commands
140 Section II: Switch Management
SHOW SNMP COMMUNITY
Syntax
show snmp community[=
community
| all]
Parameters
community
Specifies a community name.
all
Specifies all communities.
Description
Use this command to display a list of communities and the settings or the
information about the specified community. An example of the command
output is shown in Figure 20.
Figure 20. SHOW SNMP COMMUNITY Command
Another example of the command output is shown in Figure 21.
Figure 21. SHOW SNMP COMMUNITY Command with Parameter
Manager > show snmp community
SNMP community information:
Name Status Traps Access OpenAccess
---------------------------------------------------------
public Enabled Disabled read-only Yes
private Enabled Enabled read-write No
test Disabled Enabled read-only Yes
---------------------------------------------------------
Manager > show snmp community=public
SNMP community information:
----------------------------------------------------------------------
Name ................ public
Access .............. read-only
Status .............. Disabled
Trap Status ......... Disabled
Open Access ......... Yes
Traps ............... COLDSTART,WARMSTART,AUTHENTICATION,LINK
FAN,TEMPERATURE,VOLTAGE,NEWROOT,TOPOLOGYCHANGE
LOOPDETECTION,STORMDETECTION,EPSR,MSTP
TRIGGER,INTRUSION,SFP,NEWADDRESS,POE,LOGIN
Manager ........... 192.168.1.1
TrapHost .......... 192.168.1.1
TrapHost .......... 192.168.1.2
----------------------------------------------------------------------
To Next Page
Loading...
