AT-GS900M Series CLI Reference
Section II: Switch Management 157
SET SUMMER-TIME
Syntax
set summer-time start-date=
date
start-time=
time
end-date=
date
end-time=
time
offset=
offset
Parameters
start-date
Specifies the date when Daylight Saving Time starts.
end-date
Specifies the date when Daylight Saving Time starts.
start-time
Specifies the time when Daylight Saving Time starts.
date
Specifies a date in the format yyyy-mm-dd.
time
Specifies time in the format hh:mm.
offset
Specifies minutes difference between the standard time and the
Daylight Saving Time. The value is 1 to 180 minutes.
Description
Use this command to specify the Daylight Saving Time settings.
Confirmation Command
“SHOW SUMMER-TIME” on page 160
Examples
The following command specifies the the Daylight Saving Time settings:
Manager > set summer-time start-date=2015-03-08 start-time
02:00 end-date=2015-11-01 end-time=02:00 offset=60
To Next Page
Loading...
