AT-GS900M Series CLI Reference
Section II: Switch Management 167
SET TELNET
Syntax
set telnet [limit=
sessions
] [listenport=
port_number
]
Parameters
sessions
Specifies the maximum number of Telnet sessions to access the
switch at a time.
port_number
Specifies the TCP port for Telnet. The port number is from 1 to
65535. By default, the TCP port for Telnet is 23.
Description
Use this command to specify the number of sessions to allow to access
the switch at a time or change the UDP port for Telnet.
Confirmation Command
“SHOW TELNET” on page 171
Example
The following command changes the UDP port for Telnet to 120:
Manager > set telnet listenport=120
To Next Page
Loading...
