Chapter 14: Switching Commands
226 Section III: Layer 2 Switching
DELETE SWITCH TRUNK
Syntax
delete switch trunk=
trunk_name
port=
port_list
|all
Parameters
trunk_name
Specifies the name of a trunk group.
port_list
Specifies a list of ports to delete. To specify multiple ports, use a
comma (,) to separate them. To specify a range of ports, use a
hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to remove the specified ports from the trunk group.
Confirmation Command
“SHOW SWITCH TRUNK” on page 278
Example
The following command deletes port 1 from the trunk group uplink:
Manager > delete switch trunk=uplink port=1
To Next Page
Loading...
