Chapter 14: Switching Commands
246 Section III: Layer 2 Switching
ENABLE SWITCH POWERSAVE
Syntax
enable switch powersave
Parameters
None
Description
Use this command to enable the power saving mode on the switch. When
the power saving mode is enabled, the switch saves power by limiting
power on the ports with no link. By default, the power saving mode is
disabled.
When the power saving mode is enabled, the switch saves power by
limiting power on ports with no link. The ports take up to 3 seconds
to get the link up state.
Confirmation Command
“SHOW SWITCH” on page 267
Example
The following command enables the power saving mode:
Manager > enable switch powersave
To Next Page
Loading...
