AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 285
DISABLE EPSR
Syntax
disable epsr=
epsr_name
|all
Parameters
epsr_name
Specifies an EPSR domain.
all
Specifies all ESPR domains.
Description
Use this command to disable an EPSR domain.
Before executing this command, you must disable the port for the
ring either by running the DISABLE SWITCH PORT command or
unplugging the cable.
Confirmation Command
“SHOW EPSR” on page 288
Example
The following command disables the EPSR domain “espr1:”
Manager > disable epsr=epsr1
To Next Page
Loading...
