Allied Telesis AT-GS908M - Show Dhcpsnooping Macfilter

AT-GS900M Series Command Reference
Section III: Layer 2 Switching 331
SHOW DHCPSNOOPING MACFILTER
Syntax
show dhcpsnooping macfilter[= entry_id |all]
[port=
port_list |all]
Parameters
entry_id
Specifies the ID of a MAC address filtering entry.
all
Specifies all the switch ports.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to display MAC address filters. An example of the
command output is shown in Figure 50.
Figure 50. SHOW DHCPSNOOPING MACFILTER Command
Example
The following example displays MAC address filters:
Manager > show dhcpsnooping macfilter
DHCP Snooping MAC Filter ( 1 entry )
------------------------------------------------------------------
Filter ID ................ 1
VLAN ID .................. 1
Port ..................... ALL
Action ................... Permit
Is Active ................ No
------------------------------------------------------------------