AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 333
Chapter 18
Power Over Ethernet (PoE) Commands
The PoE commands are summarized in Table 36.
Table 36. PoE Commands
Command Description
“DISABLE POE PORT” on
page 334
Disables Power of Ethernet (PoE) on
ports.
“ENABLE POE PORT” on
page 335
Enables PoE on ports.
“SET POE DETECT” on
page 336
Detects IEEE compliant and legacy PDs.
“SET POE GUARDBAND” on
page 337
Specifies guard power in watts.
“SET POE MANAGEMENT” on
page 338
Specifies the power management mode to
the switch.
“SET POE PORT” on page 339 Specifies the power supply priority and
power limit on the ports.
“SET POE THRESHOLD” on
page 341
Specifies the threshold that the switch
supplies to the connected PDs.
“SHOW POE” on page 342 Displays information about PoE settings
and ports.
“SHOW POE PORT” on
page 343
Displays information about PoE ports.
To Next Page
Loading...
