Chapter 18: Power Over Ethernet (PoE) Commands
336 Section III: Layer 2 Switching
SET POE DETECT
Syntax
set poe detect[=ieee|legacy]
Parameters
ieee
Detects IEEE compliant PDs. This is the default setting.
legacy
Detects IEEE compliant PDs and legacy PDs.
Description
Use this command to specify the detect method of powered devices
(PDs).
The PoE commands are available only for the GS908M V2-4PS
switch.
Confirmation Command
“SHOW POE” on page 342
Example
The following command specifies IEEE compliant PDs:
Manager > set poe detect=ieee
To Next Page
Loading...
