Allied Telesis AT-GS908M - Show Poe Port

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 343
SHOW POE PORT
Syntax
show POE port[= port_list |all]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to display information about PoE ports. An example of
the command output is shown in Figure 53.
Figure 53. SHOW POE PORT Command
Example
The following example displays information about PoE settings and ports:
Manager > show poe port=1
PoE Port Information
--------------------------------------------------------
Port ........................... 1
PoE Status ..................... Enabled
Power Limit .................... 30000mW
Power Priority ................. LOW
Power State .................... ON - Valid PD detected
Consumed Power ................. 1900 mW
Power Class .................... 1
--------------------------------------------------------