AT-FS900M Series CLI ReferenceAT-GS900M Series CLI Reference
Section III: Layer 2 Switching 363
ENABLE STP
Syntax
enable stp [port=
port_list
|all]
Parameters
port_list
Specifies one or more ports. To specify multiple ports, use
commas to separate nonconsecutive numbers (for example 5,7,9)
or a dash to specify consecutive numbers (for example (1-4).
Description
This command is used to enable the Rapid Spanning Tree Protocol on
selected ports or the switch. By default, RSTP is disabled. To view the
current status of RSTP, use “SHOW STP” on page 371. The default
setting for RSTP is disabled.
Examples
The following command enables RSTP on ports 1 and 4:
enable stp port=1,4
The following command enables RSTP on the switch:
enable stp
To Next Page
Loading...
