Chapter 20: Rapid Spanning Tree Protocol (RSTP) Commands
374 Section III: Layer 2 Switching
SHOW STP PORTCONFIG
Syntax
show stp portconfig[=
port_list
|all]
Parameters
port_list
Specifies one or more ports. To specify multiple ports, use
commas to separate nonconsecutive numbers (for example 5,7,9)
or a dash to specify consecutive numbers (for example (1-4).
Description
You use this command to display the RSTP settings of the ports on the
switch. The parameters are defined in “SET STP PORT” on page 368. An
example of the command is shown in Figure 57.
Figure 57. SHOW STP PORTCONFIG Command
Examples
The following command displays the RSTP parameter settings for port 1:
show stp portconfig=1
The following command displays the RSTP parameter settings for all of
the ports:
show stp portconfig=all
Port | Edge-Port | Point-to-Point | Cost | Priority
--------------------------------------------------------------
1 Yes Auto Update Auto Update 128
2 Yes Auto Update Auto Update 128
3 Yes Auto Update Auto Update 128
4 Yes Auto Update Auto Update 128
5 Yes Auto Update Auto Update 128
6 Yes Auto Update Auto Update 128
7 Yes Auto Update Auto Update 128
8 Yes Auto Update Auto Update 128
To Next Page
Loading...
